W415-1699 / 02.08.16
EN
6
general information
• Prior to plugging your appliance into an electrical outlet, verify that the house circuit breakers for the outlet are on.
• The appliance may emit a slight, harmless odour when fi rst used. This odour is normal and it is caused by the initial
heating of internal appliance elements and will not occur again.
• If your appliance does not emit heat, consult the “operation” section of this manual for further information.
• Use with a CSA or UL certifi ed surge protector.
• Do not route the power cord directly underneath the appliance.
This electric applaince meets the construction and safety standards of H.U.D. for application in manufactured homes when
installed according to these instructions.
1.3 general instructions
As with most electronic devices, your new electric fi replace has been designed to operate at
temperatures between 5°C (41°F) and 35° C (95°F). During the colder winter months, allow the
fi replace to reach room temperature before turning it on.
1.4 unpacking and testing appliance
Carefully remove the appliance from the box. Prior to installing the appliance, test to make sure the appliance
operates properly by plugging the power supply cord into a conveniently located 120 volt, 15 amp grounded
outlet.
The NEFL50/60/72/100FH-EU appliances are shipped with the front glass not assembled onto the appliance.
Refer to the “front glass installation” section for assembly.
note:
CE- or GS-certifi ed
To Next Page
Loading...
Need help?
General
