ELT-400 7 Remote control
7-15
Response values:
<d.dddesdd><, unit> [, ovld] [, bat] <CR><LF>
Example: 1.234e-07, T, N, O
ª Remote control command SET:LOW_CUT, see page 7-10
ª Remote control command CALC:BAT, see page 7-17
ª Remote control command CALC:OVLD, see page 7-18
Response Explanation
unit Units of measured value; depends on the operating
mode selected by SET:MODE
• T = Tesla (in “Field strength” mode only)
• % = Percentage of limit value (in “Exposure STD”
mode only)
ovld Overload indicator; for CALC:OVLD ON only
• N = no overload, measured value valid
• ! = overload state occurred during measurement,
reject measured value
bat Battery status; for CALC:BAT ON only
• L = Battery is discharged
• O = Battery is charged
To Next Page
Loading...
