Appendix D Installing LabVIEW RT Software
FP-2000/2010/2015 User Manual D-2 ni.com
2. Right-click the FP-20xx and select Install/Upgrade Software.
The Install/Upgrade Software dialog box appears, shown in the
following figure.
3. Click Install to begin installation of LabVIEW RT files. A list of
software to be installed appears.
4. Click OK in the Select Version dialog box.
5. Another dialog box appears asking if you want to delete. Click OK.
6. Click Proceed.
7. When installation is complete, click Close to exit the Install/Upgrade
Software dialog box. Click Ye s when prompted to reboot the system.
8. After the FP-20xx has rebooted, select View»Refresh to view the
system configuration. The status should now be
Running
.
Once you assign the IP address and install the LabVIEW RT software, the
FP-20xx is configured for use with LabVIEW RT on the host PC. Refer to
Chapter 5, LabVIEW RT Programming, for more information about
targeting the FP-20xx and running LabVIEW RT applications.
To Next Page
Loading...
