National Instruments M Series - Page 398

Index
© National Instruments Corporation I-5 M Series User Manual
counters, 7-1
cascading, 7-33
connecting terminals, 7-30
duplicate count prevention, 7-35
edge counting, 7-2
filters, 7-33
generation, 7-19
input applications, 7-2
other features, 7-33
output applications, 7-19
prescaling, 7-34
pulse train generation, 7-21
retriggerable single pulse
generation, 7-21
simple pulse generation, 7-19
single pulse generation, 7-19
single pulse generation with start
trigger, 7-20
synchronization modes, 7-38
timing diagrams, B-34
counter input delays, B-34
timing signals, 7-25
triggering, 7-31
troubleshooting, C-3
counting edges, 7-2
crosstalk when sampling multiple
channels, C-1
custom cabling, 2-6
D
DACs, 5-1
DAQ
hardware, 2-1
system, 2-1
DAQ-6202, 2-2
DAQ-STC2, 2-2
data
acquisition methods, 4-11
generation methods, 5-4
transfer methods, 10-4
changing, 10-5
DMA, 10-4
IRQ, 10-4
programmed I/O, 10-4
USB Signal Stream, 10-4
Declaration of Conformity (NI resources), E-1
default
counter terminals, 7-30
NI-DAQmx counter/timer pins, 7-30
pins, 7-30
detection, troubleshooting, C-3
device
information, A-1
multiple synchronization, 9-3
NI 6220, A-2
NI 6221, A-7
NI 6224, A-24
NI 6225, A-30
NI 6229, A-45
NI 6250, A-61
NI 6251, A-66
NI 6254, A-86
NI 6255, A-92
NI 6259, A-107
NI 6280, A-129
NI 6281, A-134
NI 6284, A-139
NI 6289, A-145
pinouts, 1-1
specifications, 1-2, A-1
DI change detection, 6-8
DI Sample Clock signal, 6-4
di/SampleClock, 6-4
diagnostic tools (NI resources), E-1
DIFF connections
using with floating signal sources, 4-16
using with ground-referenced signal
sources, 4-23
when to use with floating signal
sources, 4-15