© National Instruments | A-9
NI PXIe-1085 Series User Manual
Notes For PXI slot to PXI Star mapping refer to the NI PXIe-1085 24 GB/s
PCI Express Backplane Diagram section of Chapter 1, Getting Started.
For other specifications refer to the PXI-1 Hardware Specification.
PXI Differential Star Triggers (PXIe-DSTARA, PXIe-DSTARB,
PXIe-DSTARC)
Maximum slot-to-slot skew .............................. 150 ps
Maximum differential skew.............................. 25 ps
Backplane differential impedance .................... 100 Ω ±10%
Notes For PXI Express slot to PXI_DSTAR mapping refer to the NI PXIe-1085
24 GB/s PCI Express Backplane Diagram section of Chapter 1, Getting Started.
For other specifications, the NI PXIe-1085 Series chassis complies with the
PXI-5 PXI Express Hardware Specification.
Mechanical
Overall dimensions
Standard chassis
Height ............................................... 6.97 in. (177.1 mm)
Width ................................................ 18.30 in. (464.8 mm)
Depth ................................................ 19.38 in. (492.3 mm)
Note 0.57 in. (14.5 mm) is added to height when feet are installed. When tilted with
front feet extended on table top, height is increased approximately 2.08 in. (52.8 mm)
in front and 0.583 in. (14.8 mm) in rear.
Weight............................................................... 40.3 lb (18.28 kg)
Chassis materials .............................................. Sheet Aluminum (5052-H32, 5754-H22),
Extruded Aluminum (6063-T5, 6060-T6),
Plate Aluminum (6063-T5, 6061-T6),
Cold Rolled Steel, Cold Rolled Stainless Steel,
Sheet Copper (C110), Santoprene,
Urethane Foam, PC-ABS, Nylon,
Polycarbonate, Delrin, Polyethylene,
Polyamide (FR-106), Neodymium Magnet
Finish ................................................................ Conductive Clear Iridite on Aluminum,
Electroplated Nickel on Cold Rolled Steel,
Electroplated Zinc on Cold Rolled Steel,
Electroplated Nickel on Copper
To Next Page
Loading...
