GUITAR RIG KONTROL Hardware Reference – 17
Several driver modules will be assigned to the RIG KONTROL now, each one causing a
pop-up window in which you are asked how you want to install the new device.
1. Choose not to connect to the “Windows Update Web site”.
2.
Choose “Install the software automatically” (Windows XP) or “Locate and install driver
software” (Windows Vista).
3. Follow the on-screen instructions to complete the procedure.
4.
The Windows security warnings will appear. Please ignore them and click “Continue
anyway” (Windows XP) or “Install this driver software anyway” (Windows Vista) to
properly install the drivers.
On a Windows computer, the driver is associated with a particular USB port. If you plug
the USB cable into a different port than the one it was installed at, the driver assignment
process starts again – if this happens, just follow the steps described above.
If at any time the computer does not seem to recognize the RIG KONTROL, disconnect
the USB cable, wait a few seconds, then re-connect it. If the problem remains, restart
your computer with the interface connected.
To Next Page
Loading...