User and Service Manual Xltek
®
EMU40EX™
21
Loss of pulse signal can occur when the sensor is too tight.
See the cleaning instructions in the directions for use for reusable Masimo LNOP® sensors.
Do not use damaged patient cables. Do not immerse the patient cables in water, solvents, or
cleaning solutions (the patient cable connectors are not waterproof). Do not sterilize by
irradiation, steam, or ethylene oxide. See the cleaning instructions in the directions for use for
reusable Masimo patient cables.
Wireless Option Warnings and Cautions
The wireless feature of this amplifier/headbox presents a passive visualization of the EEG
signal. This feature is not a substitute for other means of patient monitoring and supervision.
Like other wireless devices, this feature is limited in operating range. The range will also be
reduced substantially if there is any physical interference between the Base Unit and the
Breakout Box. In either of these situations, the wireless data will not be received by the
acquisition computer.
The EMU40EX contains FCC ID: R47F2M03GX which complies with part 15 of the FCC
Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
The EMU40EX contains F2M03GXA which has passed the Bluetooth
Qualification/Certification process as specified within the Bluetooth Specifications and as
required within the PRD 2.0.
QDID: B012540.
There are no devices known to cause disturbance to the performance of the wireless radios in
this device. However, precautions should be made to keep the EEG device a safe distance
from any other wireless products. Refer to Table 4 in the Declaration of Compliance for IEC
60601-1-2 section.
Should interference with the wireless radios in this device occur, relocate the devices causing
the issue, or contact Natus Technical Support at 1-800-303-0306 or OTS@Natus.com.
To Next Page
Loading...
Need help?
General
