User and Service Manual Xltek
®
EMU40EX™
59
Maintenance
1. Regularly inspect the trolley to ensure that casters, bolts, equipment mounting and shelf fasteners are
secured tight at all times.
2. Regularly inspect all wires and cables for cuts and damages.
3. Regularly inspect all electrical plugs to ensure they are securely inserted into their mating
receptacles.
Warnings and Cautions
WARNING: Only use XLTEK approved equipment on the trolley/cart. Non-approved
equipment may compromise the function and safety of the system.
Make sure that any platform, table, cart, or other surface used during the operation,
transport, or temporary or permanent storage of the system and its components is
adequate, sturdy, and safe. Natus is not responsible for any injury or damage that may
result from inadequate, poorly constructed, or unapproved transports, carts, or operating
surfaces. Natus is not responsible for any injury or damage that may result from improper
cable storage during transport.
WARNING: Do not tilt the trolley/cart more than 10° incline as this will compromise the
stability of the trolley/cart.
TIPPING HAZARD: During transport, the user should guide the cart using both hands,
ensuring the wheel base is aligned so that a single caster leads in the direction of motion.
Failure to lead the cart with one wheel could result in a tipping hazard when ascending or
descending steps or thresholds.
To Next Page
Loading...
Need help?
General
