Set during factory testing; cannot be modified
Set to ON if your network has a DHCP server. Automatically
assigns IP, netmask, gateway and nameservers.
Set to OFF if you do not have a DHCP server or if you wish
to assign static addresses.
All addresses shown are for
reference purposes only
Specify a nameserver (or DNS) to enable the use of
host names. If no nameserver is entered, only direct IP
addresses can be used to configure the email server
and any live streams such as Livewire or Shoutcast.
Typical netmask address shown. Consult with your
network administrator.
Specify the AUI port # for port forwarding. 3501 is the
default port number.
NTP = Network Time Protocol.
Set to ON to allow the network to synchronize to the trans-
mitter time.
Set to OFF to use the transmitter’s internal time reference.
Specify the IP address. Consult with your network
administrator.
Specify the gateway address. Consult with your
network administrator.
To Next Page
Loading...
