NV10LT/NV7.5LT INSTALLATION MANUAL PARTS AND TOOLS
PAGE 2.10.2 VERSION 5.0 2021-03-01
Parts Supplied by Nautel
Ancillary Parts Kit
An ancillary parts kit is shipped with the NV10LT/NV7.5LT. This kit contains items needed during the
installation process. The kit includes toroids, spare fuses, screws and miscellaneous hardware.
Documentation
See “NV10LT/NV7.5LT Transmitter Manuals” in the “About this Manual” section of the Pre-Installation
Manual.
Parts Not Supplied by Nautel
Some parts and materials required to complete installation are not supplied by Nautel. The parts you
need vary with the installation requirements. The list of parts you normally provide yourself during
installation include:
A suitable 50 RF output coaxial cable, terminated by the proper connector (e.g., field flange),
complete with center male connector (e.g., bullet) at the transmitter end.
All external control and monitor wiring, including the associated terminating devices, conduit and
conduit clamps.
All electrical power cables, including conduit, terminating devices, and conduit clamps.
Special tools, if required (e.g., torque wrench).
Parts Ordering
You can order replacement parts from the Customer Service Department, or directly from Nautel
through the Nautel website.
To Next Page
Loading...
