Assembly / Owner’s Manual
34
Condition/Problem Things to Check Solution
Pedals loose/unit difcult to
pedal/ Pedals seem to skip or
slip with a sudden increase in
rpm
Check pedal to crank
connection
Pedal should be tightened securely to crank arm. Be sure connection is not
cross-threaded. Do not use if pedal is not fully tightened.
Check crank arm to axle
connection
Crank arm should be tightened securely to axle.
Check drive belt tension Refer to the “Adjust the Belt Tension” procedure. Contact Customer Service
(if inside US/Canada) or your local distributor (if outside US/Canada).
Clicking sound when pedaling Check pedal to crank
connection
Remove pedals. Make sure there is no debris on threads, and reinstall the
pedals.
Seat post movement Check adjustment handle Be sure the adjustment handle is securely tightened.
Handlebar post movement Check adjustment handle Be sure the adjustment handle is securely tightened.
Bike will not lean Check Lean Lock Knob Be sure knob is pushed completely down (unlocked position).
Bike will not lock in Stationary
mode
Check Lean Lock Knob Be sure bike is upright. Pull the knob completely up until you hear a click.
If the Lean Lock mechanism does not click, contact Customer Service (if
inside US/Canada) or your local distributor (if outside US/Canada).
Noise/rattling from Lockout
assembly
Check Lean Lock Knob Be sure knob is pushed completely down (unlocked position).
Left and Right lean force is not
the same
Check bumper tension Refer to the “Adjust the Lean Tension” procedure in the service manual.
Contact Customer Service (if inside US/Canada) or your local distributer (if
outside US/Canada).
To Next Page
Loading...
Need help?
General
