Nautilus E10 - Upper Swingarm and Cover Installation; Connecting Upper Swingarms to Lower Swingarms

22. Identify the righthand
upper swingarm by
locating the colored dot on
the bottom of its mounting
plate. There is a
corresponding colored dot
on the righthand lower
swingarm to ensure proper
assembly.
23. Remove the (4) 1/4-20
hex head screws, (4) 1/4 flat
washers, and (4) 1/4 lock
washers that are inserted into the
lower swingarm and use them to
secure the upper swingarm to the
lower swingarm as shown in
Figure 4. Use the 7/16 socket
and ratchet to tighten.
24. Repeat Steps 22 and 23 for
the lefthand upper swingarm.
Note that there are no colored
dots on the lefthand swingarms.
25. Identify the front and rear swingarm covers. Position (1) front swingarm cover and (1) rear
swingarm cover around the righthand swingarm assembly so that the holes are aligned.
Secure the covers to the assembly using (5) 10-32 pan head screws. Use the #2 phillips head
screwdriver to tighten.
26. Repeat Step 25 for the lefthand side.
27. Identify the top and bottom cupholder covers. Position the covers around the mast
assembly so that the holes are aligned. Secure the covers to the assembly using (6) 10-32 pan
head screws. Use the #2 phillps head screwdriver to tighten.
Figure 4
assembly questions? call 800-235-2233 for help.
17