Nautilus T618 - Console Setup Mode

45
CONSOLE SETUP MODE
TheConsoleSetupModeletsyoucontrolthesoundsettings(on/o󰀨),adjustthedateandtime,orseemaintenance
statistics(TotalRunHoursandSoftwareVersion–forservicetechnicianuseonly).
1. Hold down the PAUSE/STOP button and Right() button together for 3 seconds while in the Power-Up Mode to go
into the Console Setup Mode.
Note:PushPAUSE/STOPtoexittheConsoleSetupModeandreturntothePower-UpModescreen.
2. The Console display shows the Date prompt with the current setting. To change, push the Increase()/Decrease()
buttonstoadjustthecurrentlyactivevalue(ashing).PushtheLeft/Rightbuttonstochangewhichsegmentisthecur-
rently active value (month / day / year).
3. Push OK to set.
4. The Console display shows the Time prompt with the current setting. Push the Increase/Decrease buttons to adjust
thecurrentlyactivevalue(ashing).PushtheLeft/Rightbuttonstochangewhichsegmentisthecurrentlyactivevalue
(AM or PM / hour / minute ).
5. Push OK to set.
6. The Console display shows the UNITS prompt with the current setting. Push the Increase/Decrease buttons to
change between “MILES” and “KM”.
7. Push OK to set.
8. TheConsoledisplayshowstheSoundSettingspromptwiththecurrentsetting.PushtheIncrease/Decreasebuttons
to change between “ON” and “OFF”.
If the Sound has been muted, the Console will display the “AUDIO OFF” prompt before a Workout starts as
a reminder.
9. Push OK to set.
10. The Console display shows the TOTAL RUN HOURS for the machine.
11. Forthenextprompt,pushtheOKbutton.
12. The Console display shows the BLE FW UPDATE prompt.
Note: If you have an update for the Bluetooth
®
Low Energy (also called Bluetooth
®
Smart) system, insert the USB
FlashDrivewiththeupdateleintotheConsole.PushtheIncrease/Decreasebuttonstoselectthe“CONFIRM-YES”
option, and push OK.
The Console will display “SAVING”, and then “REMOVE USB” when it is safe to remove the USB Flash Drive.
13. Forthenextprompt,pushtheOKbutton.
14. The Console display shows the Software Version code.
15. Forthenextprompt,pushtheOKbutton.
16. The Console display shows the LOG prompt.
17. Forthenextprompt,pushtheOKbutton.
18. TheConsolewilldisplaythePower-UpModescreen.