NCE NCE1DBT - Audio and Menu Settings; Audio Settings; Menu Setting Options

5
General Operation
Audio Setting
Press the VOL knob to select audio menu:
VOL/BAS/TRE/BAL/FAD, androtatetheknob
toadjust.
- VOL
Display shows the volume level VOL and
numberfrom0to40.
- BAS
DisplayshowstheBASSlevel.
BASSrange:-7to+7.
-TRE
DisplayshowstheTREBLElevel.
TREBLErange:-7to+7.
- BAL
DisplayshowstheBALANCElevel.
BALANCE range:10L(fullleft) to 10 R (full
right).
L=leftspeaker,R=rightspeaker.
- FAD
DisplayshowstheFADERlevel.
FADER range: 10 R (full rear) to 10 F (full
front).
R=rearspeaker,F=frontspeaker.
Menu Setting
Press the VOL knob more than 2 seconds
to enter into menu mode, then each press
changesthemode.
- EQ Mode
The Equalizer function applies preset sound
effectstotheunit’saudiooutputsignal.Rotate
theknobtoselectEQsoundeffect:
FLAT-CLASSIC-ROCK-POP-JAZZ-USER
Withtheequalizerfunctionactivated,ifbassor
treble isadjusted,the EQMode will revertto
“Off”.Whentheequalizerfunctionisactivated,
the mostrecently selectedbass/treble levels
cannot be adjusted. When the equalizer
functionisnotactive,theunitwillreturntothe
mostrecentlyselectedbassandtreblelevels.
- LOUD ON/ OFF
When listening tomusicat low volumes, this
featurewillselectivelyboost certainbassand
treblefrequencies.
- BEEP ON/ OFF
Thebeep tonefeature allowsthe selection of
anaudible beep tone to be heard each time
themenuisaccessed.
- SUBW ON/ OFF
Rotatetheknob tochoose subwoofer-outon
oroff.
- 12 /24 HOURS
12 HOURS MODE:
The clock displays in the type of 12 hours such
as 11:18 AM.
24 HOURS MODE:
The clock displays in the type of 24 hours such
as 20:18.
- DX/LOCAL
Selectable when the current source is Radio
mode.
Choose radio distant or local.
DX: Stations with strong and weak
signals can be broadcast.
LOCAL: Only station with strong signal can be
broadcast.
- MONO/STEREO
Selectable when the current source is Radio
mode.
This option allows you to select radio FM
mono/stereo.
- AREA SET
Thisoptionallowsyoutoselecttheappropriate
frequencyspacingforyourarea.
RotatetheknobtochooseUSAorEurope.