NCE NCE1DBT - Radio Mode; Band Selection and Tuning; Preset Station Management

6
Radio Mode
Selecting a Band
PressBANDonceormoretoselectFM1- FM2
- FM3 - AM1 - AM2.
Display shows wave band, frequency, and
presetstationnumberifalreadystored.
Selecting a Station
Press the or tuningbutton to tune to
anotherstation.
Tuning
- AUTO SEEK
Pressthe
or buttonstoseekthenext/
previousstationautomatically.
- MANUAL SEEK
Pressandholdthe
or buttonstoenter
manualtuningmode.Press thebuttonsagain
to move the radio frequency number up or
downonestep.
Note:
• During manual seeking, if the pause be-
tweentwooperating stepsis longer than5
seconds, when you continueto press
the
or buttons
, theunitwill enterauto
seeking.
• Duringmanualseeking,whenyoupressand
holdthe
or buttons
,theunitwillseek
continuously.
Preset Mode
Sixnumberedpresetbuttonsstoreand recall
stations for eachband.The storedstations
(1-6) forthe current band canbeviewedon
thescreen.
Storing Stations
- Auto storing
1.Selectaband(ifneeded).
2. Press AMSbrieyto searchall stationsin
theband,the6strongest available station
will be automatically saved in the preset
button(numbers1-6)
- Manual Storing
1. Select a band (if needed), then select a
station.
2.Pressand holda presetbutton (numbers
1-6)onthefrontpanelorremotecontrol.
3.Thepresetnumberandstationisdisplayed
andhighlighted.
Recalling a Station
1.Selectaband(ifneeded).
2. Press a front panel or remote control
preset button (numbers 1-6) to select the
correspondingstoredstation.