Chapter 3: Installation
Caution: This device should only be powered by a power supply
source which meets Safety Extra Low Voltage (SELV) and LPS (Limited
Power Source) requirements per UL1950, IEC 950, and EN 60 950. The
power source must be certified by the appropriate safety agency for the
country of installation.
Caution: Use a grounding strap when installing this feature.
Installing the 5964
The 5964 is fully assembled at the factory. This section describes:
• Serial number locations
• Connector Access
• Connector Location
• Cable Routing
• Mounting options
• Connection of 5964 to terminal
• Connection of keyboard to 5964
• Powering Up
• Screen Saving Features
Remove the 5964 from the shipping package and verify the correct
components are present before beginning installation.
To Next Page
Loading...
