3-26 Configuration
Diagnostic
• Enter Test Mode—enables the application to display the position of the key the key
is pressed.
• Press any key and the application shows the position of that key. This feature is
applicable only when testing the keyboard.
Note: If the keyboard provides the Keylock feature and the Repeat Enable option is
activated, the application continuously outputs the Keylock position to the terminal.
To stop this continuous output, press any other key.
• Exit Test Mode—enables the application to display the code program to a key when
the key is pressed.
• Load Factory Setting—reloads the default factory setting to the device.
Note: Re–plug the keyboard and close the software after successfully executing this
function.
• Reset—Resets the keyboard.
Note: This feature is applicable only when testing the keyboard.
• Firmware Version—displays the current version of the firmware.
• Get Status—displays the Keylock and drawer status of the device.
To Next Page
Loading...