NCR personaS84 ATM - Enter Supervisor Mode

Getting Started
How To Enter Supervisor Mode
2-4 NCR
SHUVRQD
V
 ATM Operator Manual
How To Enter Supervisor
Mode
2
Auto-Supervisor
2
If your ATM is fitted with the auto-supervisor facility,
opening the exterior of your ATM will automatically
cause it to enter the Supervisor Mode.
Opening the rear cabinet door will operate the
auto-supervisor switch.
When you close your ATM it will automatically return to
the Normal Mode. If you want the ATM in Normal
Mode with the exterior of the terminal open, pull-out the
button shown in the following figure.
If your ATM is not fitted with the auto-supervisor
facility, your ATM will continue to run your application
when the rear door is open. In this case you must use the
switch on the operator panel to place your ATM in the
Supervisor Mode.
Book.bk Page 4 Thursday, March 11, 1999 2:24 PM