Maintenance
Looking After Your ATM Weekly
9-4 NCR
SHUVRQD
V
ATM Operator Manual
When cleaning the exterior surface:
●
Do not use an abrasive, acid, alkaline or chlorinated
cleaner
●
Do not scrape the surface with scouring pads, razor
blades or similar implements
●
Do not use any of the following cleaning agents:
●
Benzene
●
Petrol
●
Acetone
●
Carbon tetrachloride
●
Paint stripper of any kind.
Keyboards vandalised by paint should not be cleaned.
The keyboard should be replaced.
Cleaning The Heads
On A Motorised Card
Reader
9
To clean the heads you will require a cleaning card, NCR
part number 998-0052929 or equivalent. To clean the card
reader heads proceed as follows:
1
Open the exterior of your ATM.
2
If your ATM does not have the auto-supervisor
option, press the switch on the operator panel to the
SUPERVISOR position.
3
The Supervisor Mode Executive (SME) menu will be
displayed on the operator display.
4
Press the key on the keyboard that corresponds to the
TERMINAL UTILITIES
option. The Utilities menu will
be displayed.
Book.bk Page 4 Thursday, March 11, 1999 2:24 PM
To Next Page
Loading...