Getting Started
How To Do A Hardware Reset Of Your ATM
2-36 NCR
SHUVRQD
V
îî
ATM Operator Manual
How To Do A Hardware Reset
Of Your ATM
2
A reset switch is provided on the operator panel. When
the reset switch is pressed the ATM executes its
diagnostic procedures, reloads the system software and
initialises the user application program.
To reset the ATM, proceed as follows:
1 Open the exterior of your ATM.
2 Press the reset switch on the operator panel.
Supervisor
Normal
Reset
Contrast
Book.bk Page 36 Thursday, March 11, 1999 2:24 PM
To Next Page
Loading...