Chapter 8: BIOS Updating Procedure
The BIOS is located in the Serial Peripheral Interface (SPI) chip on the processor board.
This chapter discusses procedures on how to update the terminal SPI and/or BIOS. The
update software is distributed via the NCR Website.
The BIOS update can be performed using the following methods:
• Bootable USB Memory Device
• Network – Refer to the NCR PXE Image Loader User’s Guide (B005-0000-2326) for
information about this procedure.
Prerequisites
The following are required to perform a SPI/BIOS update.
• USB Keyboard
• BIOS Software. Download
from the NCR website.
1. Select the corresponding options for the device/terminal.
Example: Retail Support Files (Drivers, Firmware, Operating Systems,
Platform Software (OPOS/JavaPOS), BIOS, etc.>>NCR POS and SelfServ
Terminal and Operating Systems >>NCR POS XR8 (7607-xxxx) >> BIOS.
2. Select the desired BIOS File.
• Network Image - Used with Network boot
• USB Memory Key Image - Used with USB boot device
3. Save the software to your local hard drive.
To Next Page
Loading...
