EasyManuals Logo

NCR POS XR8 User Manual

NCR POS XR8
152 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #91 background imageLoading...
Page #91 background image
Chapter 5: Initial Terminal Imaging
Factory default HDD/SSD images for the POS XR8 are distributed on bootable auto-
imaging USB Flash Drive media. The following procedures describe how to
apply/restore an image on the terminal.
Warning: Using this procedure will replace any previously stored OS images
created using the Disk Image Backup and Recovery Tool.
Note: A USB Keyboard is required to perform this operation.
Imaging Procedure
1. Connect the USB flash drive to the target terminal that you wish to image.
2. Connect a USB keyboard to the terminal.
3. Power on the terminal and boot from the USB Flash Drive. This can be done by
selecting F8 during the boot and choosing the USB option (NCR), or by entering
BIOS Setup and changing the boot order.
4.
The system boots in the Windows PE OS environment. Select Y on the keyboard at
the confirmation prompt to re-image the terminal.
5.
When the imaging process is complete, enter Exit on the keyboard to reboot the
system.
6. After the reboot, remove the USB Flash Drive and disconnect the keyboard.

Table of Contents

Other manuals for NCR POS XR8

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NCR POS XR8 and is the answer not in the manual?

NCR POS XR8 Specifications

General IconGeneral
BrandNCR
ModelPOS XR8
CategoryTouch terminals
LanguageEnglish

Related product manuals