Chapter 5: BIOS Updating Procedure
Introduction
This chapter discusses procedures on how to recover the Operating System. The
software is distributed on bootable CD/DVD/USB Flash Drive media.
There are two methods that can be used.
• Bootable USB DVD Drive
• USB Flash Drive (64-Bit Operating Systems)
• Network - Refer to the NCR Retail Systems Manager (RSM) Software User's Guide,
(B005-0000-1518) for information about this procedure.
Prerequisites
The following are required to perform a SPI/BIOS update.
• USB Keyboard
• BIOS Software. Download from the NCR website:
http://www.ncr.com
1. At this site, select the Support tab.
2. Select Drivers and Patches → Retail Support Files → NCR RealPOS and
SelfServ Terminal and Operating Systems →
NCR RealPOS 40 Rel. 2.0 (7600-2xxx) → BIOS.
3. Select the desired BIOS File.
• ISO Image - Used with CD ROM boot device
• Disk Image - Used with Floppy Disk boot device
• Network Image - Used with Network boot
• USB Memory Key Image - Used with USB boot device
4. Save the software to your local hard drive.
To Next Page
Loading...
