NCR RealPOS 25 - Connecting AC Power

2-42 Hardware Installation
Connecting AC Power
The 7610 receives power from an external 24 V power brick.
Caution: The 7610 requires the NCR 24 V power supply that is shipped with the
terminal. Use of other power bricks may cause damage to the unit.
1. Connect the Power Supply cable to the DC Power connector on the terminal.
2. Connect the AC Power Cord to the Power Supply and to an AC outlet.
Caution: Do not connect or disconnect the 24V Power Cable from the terminal
with the AC Power Cord connected to an AC outlet.