2-58 Hardware Installation
1. Locate the Display Mount within 4 meters (13 ft.) of the host terminal.
2. Determine if the cable should be routed down through the mounting surface or if it
should be run on top of the surface. Drill a hole if necessary.
3. If you are installing with a post greater than 215 mm (8.5 in.) secure the Base Plate
with screws (4) that are provided.
4. Connect the Interface Cable to the Display Module.
a. Remove the screws (2) from the Display Back.
b. Remove the Display Back.
c. Route the Interface Cable though the opening in the Display Back.
d. Connect the cable to the proper connector on the Display Module.
e. Reassemble the Display Assembly.
To Next Page
Loading...
