RealPOS XR7 Integration Tray Kit Instructions 11
4. Insert the Display Back Plate into the Operator Display Arm.
Cable Routing
The exploded view below shows how to route the cables up through the display mount.
5. Remove the excess slack in the cables and then install the Display Swing Arm Cover
onto the Display Swing Arm.
6. Connect the cables to the display. See the NCR RealPOS X-Series Displays User Guide
(B005-0000-2337) for additional information about cable connections.
NCR RealPOS X-Series Displays I/O Panel
To Next Page
Loading...
