NEC Express5800 Series - Page 185

1. IML Error Message
Express5800/R120h-1E, R120h-2E Maintenance Guide
185
Chapter 3 Appendix
(3) The list on the messages related to POST
Class
Error
code
Error message Action
UEFI 101
Option ROM Error. An option ROM for a
PCIe device is invalid.
Contact your sales representative.
UEFI 104 ASR Timer Failure Contact your sales representative.
UEFI 121
A Critical Error occurred prior to this
power-up.
Contact your sales representative.
UEFI 218
DIMM Initialization Error - All DIMMs are
mapped out due to memory errors except
for one to allow the system to boot.
Additional errors may be present on the
remaining DIMM. System is booting in a
degraded state.
Contact your sales representative.
UEFI 224 Power Fault Detected - FlexLOM %1
Turn off the power on the unit, disconnect the power
cord, and check the installation of FlexLOM %1. Wait 30
seconds, and then restart it. If the problem persists,
contact your sales representative.
UEFI 225 Power Fault Detected-Mezzanine %1.
Turn off the power on the unit, disconnect the power
cord, and check the installation of mezzanine %1. Wait
30 seconds, and then restart it. If the problem persists,
contact your sales representative.
UEFI 226
Power Fault Detected - Embedded Storage
Controller %1.
Turn off the power on the unit, disconnect the power
cord, and check the installation of internal storage
controller %1. Wait 30 seconds, and then restart it. If the
problem persists, contact your sales representative.
UEFI 227 Power Fault Detected - M.2 riser
Turn off the power on the unit, disconnect the power
cord, and check the installation of M.2 riser. Wait 30
seconds, and then restart it. If the problem persists,
contact your sales representative.
UEFI 244
IMPORTANT: The device in PCIe Slot %1
is SRIOV capable but is installed in a slot
that does NOT support SRIOV.
When using the SRIOV, install an optional card in the
slot where the SRIOV is supported. If the problem
persists, contact your sales representative.
UEFI 251
IMPORTANT: Switches SW1 and SW3 are
ON. This is only used to recover %1
functionality.
Set the maintenance switch to OFF unless the setting is
specified in the operating procedure etc.
When operating the maintenance switch, follow the
procedure in Chapter 1 (7. Resetting and Clearing the
Server) in this manual.
If the problem persists, contact your sales
representative.
UEFI 253
IMPORTANT: One or more embedded
PCIe Device(s) are attached to a
non-installed processor and will not
function.
Some built-in devices are not available unless the
processor is added. Add a processor if necessary. If the
problem persists, contact your sales representative.
UEFI 254
IMPORTANT: The PCIe Device installed in
Slot %1 has no corresponding processor
installed and will not function.
The optional card is connected to a PCIe slot that is not
available unless a processor is added. Change the slot
which the PCIe expansion card is connected to,
otherwise add a processor. If the problem persists,
contact your sales representative.