1. IML Error Message
Express5800/R120h-1E, R120h-2E Maintenance Guide
186
Chapter 3 Appendix
Class
Error
code
Error message Action
UEFI 261
Server Platform Services Firmware
requires update.
Update the server platform service firmware. If the
problem persists, contact your sales representative.
UEFI 266
Non-Volatile Memory Corruption Detected.
Configuration settings restored to defaults.
If enabled, Secure Boot security settings
may be lost.
The system configuration has been initialized to default.
Make the necessary settings in the system utility. If the
problem persists, contact your sales representative.
UEFI 267
IMPORTANT: Default configuration settings
have been restored at the request of the
user.
The system configuration has been initialized to default.
Make the necessary settings in the system utility. If the
problem persists, contact your sales representative.
UEFI 268
UEFI Non-Volatile Variable Store
Corruption Detected. If enabled, Secure
Boot security settings may be lost.
The system configuration has been initialized to default.
Make the necessary settings in the system utility. If the
problem persists, contact your sales representative.
UEFI 269
IMPORTANT: Default configuration settings
have been restored per user request. If
Secure Boot was enabled, related security
settings may have been lost.
The system configuration has been initialized to default.
Make the necessary settings in the system utility. If the
problem persists, contact your sales representative.
UEFI 270
%1 FW Communication Issue - Unable to
communicate with %2 FW. Certain
management functionality is not available.
Turn off the unit, disconnect the power cord, wait 30
seconds, and then restart it.
If the problem persists, contact your sales
representative.
UEFI 271
Processor %1, DIMM %2 could not be
authenticated as genuine %3. Enhanced
and extended %4 features will not be
active.
The DIMM failed to be authenticated as an authorized
part. Check the DIMM connected to the unit. If the
problem persists, contact your sales representative.
UEFI 272
IMPORTANT: Processor %1, DIMM %2
may not be a Genuine %3 DIMM.
The DIMM failed to be authenticated as an authorized
part. Check the DIMM connected to the unit. If the
problem persists, contact your sales representative.
UEFI 276
Option Card Configuration Error. An option
card is requesting more memory mapped
I/O than is available.
The memory space for the optional card failed to be
allocated. Remove the added optional card so that the
system can be booted. If the problem persists, contact
your sales representative.
UEFI 277
Secure Boot Authentication Failure - The
image on %1 failed authentication and was
not executed.
If the error occurs due to adding of the optional card,
check whether the added card supports the secure
boot. If the problem persists, contact your sales
representative.
UEFI 278
Secure Boot Authentication Failure - The
image on %1 was not authorized due to
revoked certificate(s) and was not
executed.
If the error occurs due to adding an optional card, make
sure whether the added card meets the conditions
required for secure boot. If the problem persists, contact
your sales representative.
UEFI 281
IMPORTANT: SW12 is ON indicating
physical presence. This switch should only
be ON to override certain security
protections.
Set the maintenance switch SW12 to OFF unless the
setting is specified in the operating procedure etc.
When operating the maintenance switch, follow the
procedure in Chapter 1 (7. Resetting and Clearing the
Server) in this manual.
If the problem persists, contact your sales
representative.
To Next Page
Loading...
