1. IML Error Message
Express5800/R120h-1E, R120h-2E Maintenance Guide
187
Chapter 3 Appendix
Class
Error
code
Error message Action
UEFI 282
Invalid Server Serial Number and Product
ID - The Serial Number and/or Product ID
have been corrupted or lost.
The serial number and product ID for identifying the unit
are not correctly set. Contact your maintenance service
company.
UEFI 284
DIMM Failure - Uncorrectable Memory
Error - Processor %1 Dimm %2
Contact your sales representative.
UEFI 286
IMPORTANT: The removal of a storage
device has been detected. The device has
been removed from the Boot Controller
Order.
Action is not necessary.
UEFI 287
IMPORTANT: The removal of a network
device has been detected. The device has
been removed from the Standard Boot
Order (IPL)
Action is not necessary.
UEFI 288
IMPORTANT: A new storage device has
been detected and has been added to the
end of the Boot Controller Order.
Action is not necessary.
UEFI 289
A new network or storage device has been
detected. This device will not be shown in
the Legacy BIOS Boot Order options in
RBSU until the system has booted once.
Action is not necessary.
UEFI 291
IMPORTANT: The Standard Boot Order
(IPL) has been detected as corrupted and
has been restored to default values.
Action is not necessary.
UEFI 292
Invalid %1 Software RAID
Configuration. %2 SW RAID Mode is NOT
supported when the Boot Mode is
configured for legacy BIOS Mode.
When using the corresponding Software RAID, the boot
mode must be changed to the UEFI mode. If the
problem persists, contact your sales representative.
UEFI 297
IMPORTANT: iLO Security is disabled by
the associated switch being set to the ON
position. Platform security is DISABLED.
The maintenance switch SW1 should be set to OFF
unless the setting is specified in the operating
procedure etc.
When operating the maintenance switch, follow the
procedure in Chapter 1 (7. Resetting and Clearing the
Server) in this manual.
If the problem persists, contact your sales
representative.
UEFI 311
%1 Configuration Error - The system has
exceeded the installed battery capacity.
Add more batteries for the capacity increase, or reduce
the number of devices that need battery backup. If the
problem persists, contact your sales representative.
UEFI 312
%1 %2 Failure - Communication with the
battery failed. Its output may not be
enabled.
Make sure that the battery is correctly installed. If the
problem persists, contact your sales representative.
UEFI 315
An uncorrectable memory error was
detected prior to this system boot.
Contact your sales representative.
UEFI 319
An Unexpected Shutdown was detected
prior to this boot.
Action is not necessary.
To Next Page
Loading...
