NEC Express5800 Series - Page 188

1. IML Error Message
Express5800/R120h-1E, R120h-2E Maintenance Guide
188
Chapter 3 Appendix
Class
Error
code
Error message Action
UEFI 320
Enclosure Power Event detected. Boot
delayed until condition is resolved.
Action is not necessary.
UEFI 321
%1 Dual microSD Device Unsupported
Configuration - A microSD card is not
installed in Slot %2
Make sure whether the corresponding microSD card is
correctly mounted. If the problem persists, contact your
sales representative.
UEFI 322
%1 Dual microSD Device Unsupported
Configuration - No microSD cards are
installed.
Make sure whether the corresponding microSD card is
correctly mounted. If the problem persists, contact your
sales representative.
UEFI 323
%1 Dual microSD Device Error - The
microSD card in Slot %2 has failed.
Contact your sales representative.
UEFI 324
%1 Dual microSD Device Error - Both
microSD cards have failed.
Contact your sales representative.
UEFI 325
%1 Dual microSD Device Error - microSD
cards have conflicting metadata.
Configuration required.
Use the system utility to set up the primary microSD
card. If the problem persists, contact your sales
representative.
UEFI 326
%1 Dual microSD Device Error - The
microSD card in Slot %2 has failed. A
microSD card is not installed in Slot %3.
Contact your sales representative.
UEFI 327
AMP Configuration Error - An installed
processor does NOT support the
configured AMP Mode. System will
operate in Advanced ECC Mode.
Contact your sales representative.
UEFI 328
Power Management Controller Firmware
Error - The firmware is in Recovery Mode.
Update the firmware of the power management
controller. If the problem persists, contact your sales
representative.
UEFI 329
Power Management Controller FW Error -
Unable to communicate with the FW.
Please take actions in the following order.
1. Turn off the unit, disconnect the power cord, wait 30
seconds, and then restart it.
2. If the problem persists, contact your sales
representative.
UEFI 333
%1 RESTful API Error - Unable to
communicate with iLO FW. BIOS
configuration resources may not be
up-to-date.
Please take actions in the following order.
1. Reset the iLO following the procedure of Chapter 1
(7. Resetting and Clearing the Server) in this manual.
Also, restart the unit.
2. If the problem persists, turn off the power of the unit,
disconnect the power cord, wait 30 seconds, and then
restart it.
3. If the problem persists, contact your sales
representative.