NEC Express5800 Series - Page 195

1. IML Error Message
Express5800/R120h-1E, R120h-2E Maintenance Guide
195
Chapter 3 Appendix
Class
Error
code
Error message Action
UEFI 411
Innovation Engine Error - The Innovation
Engine is operating in recovery mode.
Set the maintenance switch SW12 to OFF unless the
setting is specified in the operating procedure etc.
When operating the maintenance switch, follow the
procedure in Chapter 1 (7. Resetting and Clearing the
Server) in this manual.
If the problem persists, contact your sales
representative.
UEFI 414
Server Platform Services Firmware Error -
The SPS Firmware is not operating
properly. (Error Code %1).
Updating the latest server platform service firmware
may solve the error. Please update the server platform
service firmware.
If the problem persists, contact your sales
representative.
UEFI 415
IMPORTANT: The Innovation Engine
Firmware revision in this system does not
meet minimum requirements for operation
with NVDIMMs. All NVDIMM functionality
has been disabled.
Updating the latest Innovation Engine Firmware may
solve the error. Please update the Innovation Engine
Firmware.
If the problem persists, contact your sales
representative.
UEFI 420
TLS certificate verification error 0x%1 while
downloading from %2:%3.
Register the certificate required for authentication, and
check the TLS setting.
UEFI 421
TLS certificate verification failed due to
hostname mismatch.
Check whether the certificate required for authentication
has been registered, or check the TLS setting.
UEFI 422
TLS certificate verification failed. The
passed certificate is self-signed and the
same certificate cannot be found in the list
of trusted certificates.
Check whether the certificate required for authentication
has been registered, or check the TLS setting.
UEFI 423
TLS certificate verification failed. The
issuer certificate of a looked up certificate
could not be found. This normally means
the list of trusted certificates is not
complete.
Check whether the certificate required for authentication
has been registered, or check the TLS setting.
UEFI 424
No TLS certificate enrolled. At least one
certificate authority must be enrolled when
TLS verification mode is set to PEER.
Register the certificate required for authentication, and
check the TLS setting.
UEFI 430
Scalable Persistent Memory uncorrectable
memory error on %1 Logical NVDIMM %2.
The memory region will not be available to
the OS and data may have been lost.
Contact your sales representative.
UEFI 431
Scalable Persistent Memory backup failed
on %1 Logical NVDIMM %2. Persistent
data has been lost.
Contact your sales representative.
UEFI 432
Scalable Persistent Memory restore failed
for %1 Logical NVDIMM %2. Persistent
data may have been lost.
Contact your sales representative.