NEC Express5800 Series - Page 218

1. IML Error Message
Express5800/R120h-1E, R120h-2E Maintenance Guide
218
Chapter 3 Appendix
Class
Error
code
Error message Action
System Revision 3 #ILO detected invalid %1 firmware.
If the record continues, contact your
maintenance service company.
System Revision 4
#ILO was unable to automatically repair
the %1 firmware.
Update the server platform service firmware. If
the problem persists, contact your sales
representative.
System Revision 7
#ILO completed the firmware integrity scan
and detected an anomaly.
Action is not necessary.
System Revision 8 Firmware recovery is requested by %1 Action is not necessary.
Maintenance 1 IML Cleared (%1 user: %2) Action is not necessary.
Maintenance 2 Maintenance note: %1 Action is not necessary.
Power Cap 1
Processor(s) Operating at Reduced
Performance Level Due to a Low Power Cap
Contact your sales representative.
Power Cap 3
Power Cap Cannot Be Reached With
Current System Configuration (Power
Cap %1W)
Contact your sales representative.
Power Cap 4
Power allocation not optimized. Increased
power allocation requested. Server
performance is not degraded
Contact your sales representative.
Flash Media 1 Boot From Flash Error (%1) Connect the USB memory device again.
Flash Media 2
A read error occurred on the Flash Media in
Slot %1 of a USB storage device attached to
the system
Contact your sales representative.
Flash Media 3
A write error occurred on the Flash Media in
Slot %1 of a USB storage device attached to
the system
Contact your sales representative.
Flash Media 4
Redundancy is lost on a USB storage device
attached to the system. Flash Media in
Slot %1 has failed
Contact your sales representative.
Flash Media 5
Sync operation to restore redundancy failed
on a USB storage device attached to the
system
Contact your sales representative.
Interlock 1
Improperly seated or missing device
(%1, %2)
Contact your sales representative.