NEC Express5800 Series - Page 217

1. IML Error Message
Express5800/R120h-1E, R120h-2E Maintenance Guide
217
Chapter 3 Appendix
Class
Error
code
Error message Action
Drive Array 1F
Solid state disk wear status is now %d for
drive at location %s connected to controller
in %s.
Contact your sales representative.
Drive Array 20 ATA disk drive status is now %d for drive %d Contact your sales representative.
Drive Array 21
%1 Smart Array - Logical drive status
changed to %2
Contact your sales representative.
Drive Array 23
%1 Smart Array - Cache module board lost
backup power
Contact your sales representative.
Drive Array 24
%1 Smart Array - Cache module board
backup power source status is failed
Contact your sales representative.
Drive Array 28
Storage system fan status changed to %1 for
location %2 connected to controller %3
Contact your sales representative.
Drive Array 29
Storage system temperature status changed
to %1 for location %2 connected to
controller %3.
Contact your sales representative.
Drive Array 2A
Storage system power supply status
changed to %1 for location %2 connected to
controller %3
Contact your sales representative.
Drive Array 2B
Storage system connection status changed
to %1 for location %2 connected to
controller %3
Contact your sales representative.
Drive Array 2C
%1 Smart Array - Spare status is changed
to %2
Contact your sales representative.
System Error 5
Unrecoverable I/O Error has occurred.
System Firmware will log additional details in
a separate IML message entry if possible.
Contact your sales representative.
System Error 7
Server Critical Fault (Service
Information: %1)
Contact your sales representative.
System Error 8
Enclosure Induced Event (Service
Information: Enclosure Power Loss, %1)
Action is not necessary.
System Revision 2 Firmware flashed (%1) Action is not necessary.