NEC ITL-8LD-1 - DT730 - 8 Button DESI Less Display IP Phone - Page 100

92
STEP 15:Select Server Address.
Select an item by either of the following operations.
• Highlight an item by using , and then press ,
or OK soft key.
• Press key.
STEP 16:Enter an IP address of the FTP/TFTP server
which stores the backup file. For example, to
set the IP address of 10.41.208.205, enter
10*41*208*205 [separate with an asterisk
(*)].
After entering an IP address, press or
OK soft key.
STEP 17:The display goes back to the Backup/Re-
store screen. Select Data Restore.
Select an item by either of the following operations.
• Highlight an item by using , and then press ,
or OK soft key.
• Press key.
STEP 18:The default file name will be displayed as fol-
lows:
3
3
1
2
[Backup/Restore]
3
4
OKBack
↓
Data Backup
Data Restore
↓
5
FTP Settings
Protocol
Server Address
[Server Address]
OKBack
BK
1
‘*‘For‘.‘
.
.
.
2
Note:
Do not change the extension (.tgz) of the backup
file. If the extension is changed, the file cannot be
restored properly.
Note:
When changing the default file name, press BK
soft key once to delete the default file name and
then enter a new file name by using the digits
keys.
Note:
For details on character entry method, see HOW
TO INPUT CHARACTERS in chapter 4 Basic
Operation.
2
1
2
[Backup/Restore]
3
4
OKBack
↓
Data Backup
↓
5
FTP Settings
Protocol
Server Address
Data Restore
ExecCancel
BK
A
[Data Restore]
Input a folder name.
PersonalData.tgz