NEC ITL-8LD-1 - DT730 - 8 Button DESI Less Display IP Phone - Page 196

188
STEP 14:The display goes back to the Edit screen. Se-
lect Ring Tone.
Select an item by either of the following operations.
• Highlight an item by using , and then press ,
or OK soft key.
• Press key.
STEP 15:Select a desired Ringing Tone.
Select an item by either of the following operations.
• Highlight an item by using , and then press
or OK soft key.
• Press - key, and then press or OK soft
key.
STEP 16:The display goes back to the Edit screen. Se-
lect Illumination.
Select an item by either of the following operations.
• Highlight an item by using , and then press ,
or OK soft key.
• Press key.
8
8
1
2
[Edit]
3
4
5
OK
Back
6
7
8
9
0
Save
Gr
No
Ken Kobus
Tel #4
Tel #2
Tel #3
Illumination
0
Colleagues
31300
Ring Tone
NEC
0
9
Note:
You can set ringer tone for calls routed to the
specified name (calling party) here. Ringer Tone
type can be set for “Name”, “Group” and “Tele-
phone set”. The ringer Tone type set for “Name”
has higher priority than the types set for “Group”
and “Terminal set”.
Note:
Set 2 Default when you don’t want to change the
ringer tone here. The setting for “Group” or “Tele-
phone set” is applied. Also, when 1 Automatic is
set, 3 Tone Type 1 is automatically applied.
Note:
For details on each ringer tone type, see TO SET
RINGER TONE.
1
2
[Ring Tone]
3
16
17
18
19
Automatic
OKBack
Download 1
Tone Type 14
Default
Tone Type 1
↓
Download 3
Download 2
:
9
9