English−13
Mounting (for Customer)
WARNING: Please refer to “WARNING 7”.
Please contact your supplier as they may be able to provide a list of qualified installation professionals. Mounting on a wall or
ceiling and hiring a technician is the customer’s responsibility.
Maintenance
• Periodically check for loose screws, gaps, distortions, or other problems that may occur with the mounting equipment.
If a problem is detected, please refer to qualified personnel for service.
• Regularly check the mounting location for signs of damage or weakness that may occur over time.
WARNING: Please refer to “WARNING 8”.
Prevent Tipping
WARNING: Please refer to “WARNING 8” and “WARNING 9”.
Screw (M4)
Cord or chain
Clamp
Screw Holes
Screw (M4)
Cord or chain
Clamp
Screw Holes
Without eyebolt brackets With eyebolt brackets
Before attaching the monitor to the wall, make sure that the wall can support the weight of the monitor.
Changing the Logo Ornament Position
When using the monitor in the portrait position, the logo ornament
position can be changed.
Removing the logo ornament: Unscrew the installed screw then take off
the logo ornament.
Attaching the logo ornament: Make sure the holes for the screws on
the logo ornament and the holes for the screws on the bezel are aligned.
Install the logo ornament with the screws, which are used for installing the
logo ornament.
(Recommended Fasten Force: 30-40 N•cm).
NOTE: Do not use any other screw to install the logo ornament.
Screw holes
To Next Page
Loading...
