English−21
Terminal Panel
USB
DisplayPort
HDMI2
HDMI1 (ARC)
LAN
AUDIO OUT
REMOTE
HDMI
A AC IN Connector
Connects with the supplied power cord.
B Main Power Switch
On/Off switch to turn main power ON/OFF.
C AUDIO OUT
Audio signal output from DisplayPort and HDMI to an
external device (stereo receiver, amplifier, etc.).
NOTE: This connector is not a headphone terminal.
D REMOTE
Use the optional sensor unit by connecting it to your monitor.
NOTE: • Do not use this connector unless specified.
• When the optional sensor unit is connected, the
monitor’s remote control sensor is disabled.
E LAN Port IN (RJ-45)
Connect to LAN in order to manage and control the monitor
over the network. See page 52.
F DisplayPort IN
DisplayPort signals input.
G HDMI IN (HDMI1 (ARC)/HDMI2)
HDMI signals input.
NOTE: • HDMI1 terminal also supports ARC (Audio
Return Channel) for audio output.
• ARC sends the monitor’s sound to audio
equipment with an HDMI1 ARC connector.
• Use the included ARC-supported HDMI cable.
The audio equipment will output the monitor’s
audio.
• The audio equipment can be controlled with the
included remote control.
H USB Port
USB storage device reader for use with the Media Player.
Power supply for USB devices.
For the USB port information, please see “Connecting a
USB Device” on page 31.
I Option Board Slot
Slot for installation of a Slot 2 type Option Board.
NOTE: Please contact your supplier for a list of compatible
Option Boards.
J RS-232C IN (D-Sub 9-pin)
Connect RS-232C input from external equipment, such
as a computer, in order to control RS-232C functions.
See page 51.
To Next Page
Loading...
