NEC NC1700L - Page 112

112
Appendix
Error Code Error message Description
577 IMB:Security Battery Event A Battery Tamper event has been detected with the IMB.
581 IMB:Security Enclosure Not Armed IMB security not armed.
582 IMB:Physical Marriage Tamper The IMB has detected a break of the Marriage with the
projector.
583 IMB:Logical Marriage Tamper The IMB has detected an error with the verification of the
Marriage with the projector.
584 IMB:Marriage NOT Active The IMB has not established a marriage with the projector
586 IMB:Service Door Tamper Latched service door tamper condition on IMB
588 IMB:Security Battery Low Warning Close to “(577) IMB: Security Battery Event”.
700 OPT Comm Fail Failed to communicate with slave MCU.
701 OPT Status Fail Slave MCU is in unexpected status.
703 OPT Comm Ack Fail Slave fails to execute the command.
740 SensorFail Inlet Failed to read inlet sensor.
741 SensorFail DMD Failed to read DMD sensor.
750 OverTemp.DMD Precaution Set inside temperature (DMD) is close to over
temperature.
751 OverTemp.Inlet Precaution Set inside temperature (Inlet) is close to over temperature.
760 OverTemp.DMD Set inside temperature (DMD) is abnormal.
761 OverTemp.Inlet Set inside temperature (Inlet) is abnormal.
762 OverTemp.Light Set inside temperature (Light) is abnormal.
783 EepromFail Slave MCU failed to read back all of data from EEPROM
on slave MCU board due to unexpected data or
something.
(Slave board internal abnormality)
791 FanInitError Failed to initialize fans.
792 ExGpioFail Failed to control the signal connecting to Ballast.
(Slave board internal abnormality)
800 Fan15 Stop Fan15 has stopped.
801 Fan16 Stop Fan16 has stopped.
802 Pump Stop Pump has stopped.
804 PhosphorWheel Stop Phosphor Wheel has stopped.
805 Diffuser1 Wheel Stop Diffuser1 Wheel has stopped.
806 Fan17 Stop Fan17 has stopped.
810 Fan15 Stop Precaution Fan15 Stop Precaution
811 Fan16 Stop Precaution Fan16 Stop Precaution
812 Pump Stop Precaution Pump Stop Precaution
814 PhosphorWheel Stop Precaution Phosphor Wheel Stop Precaution
815 Diffuser1 Wheel Stop Precaution Diffuser1 Wheel Stop Precaution
816 Fan17 Stop Precaution Fan17 Stop Precaution
906 LD Version Read Fail Failed to read Laser Driver Software version.
913 TiltDegreeOver Projector tilt degree is out of spec.
To clear this warning, turn off and AC-OFF the projector,
then setup projector with proper tilt angle within the spec.
914 LowerTemp Set inside temperature (Inlet) is lower temperature.
933 SensorFail PhosphorWheel Set inside temperature (Phosphor Wheel) is abnormal.
953 OverTemp.PhosphorWheel Precaution Set inside temperature (Phosphor Wheel) is close to over
temperature.
973 OverTemp.PhosphorWheel Set inside temperature (Phosphor Wheel) is abnormal.
982 ColorSensorFail Failed to control color sensor.
984 GSensorError Failed to control G-sensor.
985 LD CommError In I2C communication between slave uC and LD (Laser
Driver) uC, no ack from LD uC.
(Slave uC: I2C slave, LD uC: I2C host)
988 LensInstallSWOpen Lens install switch is open.
989 BrightnessLow Brightness has lowered.