23
9. NETWORK SETTINGS
CongurationforconnectingthisdevicetoawiredLANorwirelessLAN.
9-1. PROJECTOR NAME
Set the projector name and host name. The default factory setting is the manufacturing number of this device.
Item Description Remarks
Projector name Set up the projector name
Amaximumof16alphanumeric
characters
Host name Set the host name of this device.
Amaximumof16alphanumeric
characters
9-2. NETWORK INFORMATION
Display the information when this device is connected to a network (wired LAN / wireless LAN).
9-3. WIRED LAN
CongurethesettingsforconnectingthisdevicetoawiredLAN.
Item Description Remarks
Prole The settings when connecting this device to a wired LAN can
beregisteredin2ways(Prole1andProle2).
DHCP/IP ADDRESS/
S U B N E T MA S K /
GATEWAY/AUTO-
MATIC DNS
Perform required settings
Reconnection Try connecting to the network again. Reconnect after chang-
ing the settings.
9-4. Wireless LAN
CongurethesettingsforconnectingthisdevicetoawirelessLAN.
Item Description Remarks
Prole
Selectthecongurationnamewhenconnectingthisdevice
to a wireless LAN.
• Disable:Noradiowaveswillbetransmittedfromthewire-
less LAN unit connected to this device.
• Simpleaccesspoint:Connecttoacomputerorsmartphone
by setting this device as a simple access point.
• Wi-Fi Direct: Connect to a devicecompatiblewithWi-Fi
Direct.
• Miracast:ConnecttoadevicecompatiblewithMiracast
• Prole1/Prole2:ThewirelessLANsettingscanbereg-
istered in 2 ways.
• Thedefaultfactorysetting
when shipped is “Disable”.
• Ifasimpleaccesspoint
has been set up, the IP
address of this device
willbe“192.168.120.1”or
“192.168.130.1”.
NOTE: When a simple access
pointissetup.Upto20unitscan
beconnectedsimultaneously.
Recommend to connect approx.
10 units for normal operation.
DHCP/IP address/
Subnet mask/Gate-
way/DNS
ThesecanbesetwhenProle1orProle2isselected.
Advanced settings Thecongurationitemsdifferforeachproleoption.Refer
to the following table.
Reconnection Try connecting to the network again. Reconnect after chang-
ing the settings.