NEC NP-UM352W - Remote Pen and Touch Module Adjustment

33
10. TOOLS
3. Touch all 25 positions.
Complete the position adjustment and the message of calibration
completion will be displayed on.
PRESS BRIEFLY ON THE RED DOT WITH STYLUS (NO FINGER) TO CALIBRATE (SET TOP LEFT).
PRESS [EXIT] TO CANCEL CALIBRATION
NOTE:
• Youmaynotabletoperformmanualcalibrationbytheaffectionofthelightfromoutside.
Remote Pen
1. Same as the “❽ Operating Your Computer’s Mouse Functions from the Projector’s Remote Control via
the USB Cable (Remote Mouse Function)”, connect the projector and the computer by the supplied USB
cable.
2. Focus on the [REMOTE PEN] in the [PEN SETTINGS] and press ENTER.
The checked mark is added.
3. Press the USB-B button on the remote control.
Or select [USB-B] as the [SOURCE] on the onscreen menu.
The computer screen will be displayed on.
4. Start the latest IWB Setup Software for the white board kit onto the computer and perform calibration.
The stylus pen becomes available for operations as a computer mouse.
• ThestyluspencanbeusedondisplayedimagefromterminalsbesidesUSB-B.
NOTE:
• Whiletheremotepenisavailable,theoperationsbyacomputermousecanbeperformedbythestyluspenbuttheoperations
ontheprojector[APPSMENU]andthe[WHITEBOARD]cannotbeperformedbythestyluspen.