Need help?Do you have a question about the NEC NP4100 and is the answer not in the manual?
General| Vertical scan range | 50 - 85 Hz |
|---|---|
| Horizontal scan range | 15 - 90 kHz |
| Projection technology | DLP |
| Contrast ratio (typical) | 2100:1 |
| Projector native resolution | XGA (1024x768) |
| Lamp power | 280 W |
| Light source type | Lamp |
| Service life of light source | 2000 h |
| Service life of light source (economic mode) | 3000 h |
| Focal length range | 26 - 34 mm |
| Analog signal format system | NTSC, PAL, SECAM |
| RMS rated power | 3 W |
| Number of built-in speakers | 2 |
| Headphone outputs | 1 |
| Serial interface type | RS-232 |
| Dimensions (WxDxH) | 505 x 385 x 209 mm |
| Noise level | 38 dB |
| Power consumption (typical) | 710 W |
Weight and Dimensions| Weight | 17500 g |
|---|
Highlights major features like lens controls and zoom capabilities.
Explains throw distance requirements for various screen sizes.
Covers connecting PCs, monitors, DVD players, VCRs, and networks.
Step-by-step instructions for safely turning the projector on and off.
Guides users on how to choose the active input signal for display.
Setup for locking the projector to prevent unauthorized use.
Troubleshooting steps for issues like no image, blurriness, or distortion.
Solutions for problems related to lamp failure and remote control response.
To Next Page
