1. Introduction
14
Battery Installation
The Remote Control unit included with the projector does not contain batteries, though
batteries are supplied as part of the complete package. To insert (or replace) the batter-
ies, refer to the following guide.
1.
Remove the battery compartment
cover by squeezing the locking
catch (A) and sliding the cover in
the direction of the arrow (B).
2.
Insert the supplied batteries tak-
ing note of the polarity (+/-) as
shown.
3.
Replace the cover locator (A),
and then click locking catch into
place (B).
To Next Page
Loading...
