1. Introduction
13
Important:
1. Avoid using the projector with bright fluorescent lighting turned on. Certain high-
frequency fluorescent lights can disrupt remote control operation.
2. Be sure nothing obstructs the path between the remote control and the projec-
tor. If the path between remote and projector is obstructed, you can bounce the
remote signal off certain reflective surfaces such as projector screens.
3. The buttons and keys on the projector have the same functions as the corre-
sponding buttons on the remote control. This user’s manual describes the
functions based on the remote control.
Note:
*To turn off the projector, press the Power OFF button twice.
**To turn on the projector, press and hold the Power On button for a minimum of
two seconds.
To Next Page
Loading...
