Amendix B
PaDer
SDecifications
49
NOTE:
With
2-ply forms (1 plus original), punched tucks (crimped perforations that hold
the paper layers together) are permissible along both sides of the form. All
3-ply
and
4-
ply forms (2 or 3 plus original) must be spot-glued on
both sides, or one
side spot-glued
with the other punched tucks. Staples cannot be used to bind multi-ply forms.
Tables B-3, B-4 and B-5 and the corresponding figures describe the dimensions of the
print area of a cut sheet, continuous forms and envelopes.
Table B-3
Print Area Dimensions for Sheet Guide
Dimensions
Description
Measurements
AandB
Margins
(Normally
non-printing area)
12.7 mm min. (0.5 in. min.)
C
Distance from the top edge to the middle
23.6 mm (0.93 in.)
of the first print
lime
C
Distance from the top edge to the bottom
2514
mm (1 in.)
of the first print
line
D
Diiance from the bottom edge to the
27.1 mm min. (1.07 in. min.)
middle of the last ptint line
D
Distance
from the bottom edge to the
25.4 mm min. (1 in. min.)
bottom of the
Iast
print lime
FifStPrintPOSikfl
Laspnt
Position
To Next Page
Loading...