NEC QX-S5500G Series - Page 108

Installation Guide
QX-S5500G Series Ethernet Switches
6. Upgrading software
6-37
Figure 6-15 File transfer progress
10) Enter Y at the prompt to upgrade the basic Boot ROM section.
Loading ...CCCCCCCCCCCCCC ...Done!
Will you Update Basic BootRom? (Y/N):Y
Updating Basic BootRom...........Done.
11) Enter Y at the prompt to upgrade the extended Boot ROM section.
Updating extended BootRom? (Y/N):Y
Updating extended BootRom.........Done.
12) If the baud rate of the HyperTerminal is not 9600 bps, restore it to 9600 bps at the
prompt. If the baud rate is 9600 bps, skip this step.
Please change the terminal's baudrate to 9600 bps, press ENTER when ready.

NOTE:
The console port rate reverts to 9600 bps at a reboot. If you have changed the baud rate, you must perform this
step so you can access the switch through the console port after a reboot.
13) Press Enter to access the Boot ROM update menu.
14) Enter 0 in the Boot ROM update menu to return to the Boot menu.
1. Update full BootRom
2. Update extended BootRom