NEC QX-S5500G Series - QX-S5524 GP-4 X1 C Panel Views

Installation Guide
QX-S5500G Series Ethernet Switches
1. Product overview
1-5
Figure 1-8 QX-S5548GT-4X1C rear panel
(1) Grounding screw
(2) Interface card slot
(3) Fan tray slot1
(4) Fan tray slot2
(5) Power module slot1
(6) Power module slot2
The QX-S5548GT-4X1C switch comes with power module slot 1 empty and power module
slot 2 installed with a filler panel. You can install one or two power modules for the switch as
required. In this figure, two PSR150-A1 AC power modules are installed in the power
module slots. For more information about installing and removing a power module, see
"Installing/removing a power module."
The QX-S5548GT-4X1C switch comes with the two fan tray slots empty. You must install
two fan trays of the same model for the switch. In this figure, two LSPM5FANSA fan trays
are installed in the fan tray slots. For more information about installing and removing a fan
tray, see "Installing/removing a fan tray."
The QX-S5548GT-4X1C switch comes with a filler panel in the interface card slot. You can
select an interface card for the switch as required. In this figure, an LSWM5QP2P interface
card is installed in the interface card slot. For more information about installing and
removing an interface card, see "Installing/removing an interface card."
1.5 QX-S5524GP-4X1C panel views
Figure 1-9 QX-S5524GP-4X1C front panel