NEC QX-S5500G Series - Operation Mode

Installation Guide
QX-S5500G Series Ethernet Switches
9. Appendix B FRUs and compatibility matrixes
9-9
V. LSWM5XGT8PM
(1) 1/10GBase-T port
(2) 1/10GBase-T port LED
(3) Screw
(4) Handle
Table 9-6 The port LED of 1/10GBase-T description
LED status Description
Steady green
The port has a link and is operating at 10 Gbps.
Flashing green
The port is sending or receiving data at 10 Gbps.
Steady yellow
The port has a link and is operating at 1 Gbps.
Flashing yellow
The port is sending or receiving data at 1 Gbps.
Off
No link is present on the port.
9.3.2 Operation mode
An expansion interface card can specify an operation mode using the
port-configuration-mode command.
This command is effective only by the QX-S5548GT-4X1C.
 0－All ports on an expansion interface card are invalid.
 1－Port 5 to port 8 on an expansion interface card is invalid.
 2－A port of GigabitEthernet 1/0/41 to GigabitEthernet 1/0/48 of a front panel is
invalid.