NEC QX-S5500G Series - Page 14

Installation Guide
QX-S5500G Series Ethernet Switches
1. Product overview
1-6
(1) SFP port
(2) SFP port (Combo port, port 17S to 24S)
(3) SFP port LED (4) 10/100/1000 BASE-T autosensing Ethernet port
(Combo port, port 17T to 24T)
(5) 10/100/1000 BASE-T autosensing Ethernet port LED
(6) Management Ethernet port
(7) Console port
(8) USB mini Console port
(9) Port LED mode switching button
(10) USB port
(11) System status LED (SYS)
(12) SFP+ port
(13) Port mode LED
(14) Interface card status LED (SLOT)
(15) Power module 2 status LED (PWR2)
(16) Power module 1 status LED (PWR1)
(17) SFP+ port LED
(18) Management Ethernet port LED
Figure 1-10 QX-S5524GP-4X1C rear panel
(1) Grounding screw
(2) Interface card slot
(3) Fan tray slot1
(4) Fan tray slot2
(5) Power module slot1
(6) Power module slot2
The QX-S5524GP-4X1C switch comes with power module slot 1 empty and power module
slot 2 installed with a filler panel. You can install one or two power modules for the switch as
required. In this figure, two PSR150-A1 AC power modules are installed in the power
module slots. For more information about installing and removing a power module, see
"Installing/removing a power module."
The QX-S5524GP-4X1C switch comes with the two fan tray slots empty. You must install
two fan trays of the same model for the switch. In this figure, two LSPM5FANSA fan trays
are installed in the fan tray slots. For more information about installing and removing a fan
tray, see "Installing/removing a fan tray."
The QX-S5524GP-4X1C switch comes with a filler panel in the interface card slot. You can
select an interface card for the switch as required. In this figure, an LSWM5QP2P interface
card is installed in the interface card slot. For more information about installing and