Installation Guide
QX-S5500G Series Ethernet Switches
3-25
Figure 3-30 A of parts through DC power cord
2) A terminal for DC power cord is connected to B of parts. When connecting, please
connect so that it may correspond to a connector on the switch side. Please fix by the
screw which sticks to the upper part after connecting, so that a terminal doesn't come
off.
Figure 3-31 B of parts and connection of DC power cord
3) You combine B of parts with A of parts, tighten a screw and fix. There is a part where a
cable is fixed in A of parts. Please fix by tie-wrap (wire band) etc.
To Next Page
Loading...
