NEC QX-S5500G Series - Page 87

Installation Guide
QX-S5500G Series Ethernet Switches
6. Upgrading software
6-16
more information about password recovery capability, see Chapter 1 Fundamentals
Configuration Guide in QX-S5500G Switch Series Configuration Guides.
Password recovery capability is enabled.
EXTENDED BOOT MENU
1. Download image to flash
2. Select image to boot
3. Display all files in flash
4. Delete file from flash
5. Restore to factory default configuration
6. Enter BootRom upgrade menu
7. Skip current system configuration
8. Set switch startup mode
9. Set The Operating Device
0. Reboot
Ctrl+Z: Access EXTENDED ASSISTANT MENU
Ctrl+F: Format file system
Ctrl+P: Change authentication for console login
Ctrl+R: Download image to SDRAM and run
Enter your choice(0-9):
Table 6-4 Extended Boot ROM menu options
Option Tasks
1. Download image to flash
Download a software image file to the flash.
2. Select image to boot

Specify the main and backup software image file for the next startup.

Specify the main and backup configuration files for the next startup.
This task can be performed only if password recovery capability is
enabled.
3. Display all files in flash
Display files on the flash.
4. Delete file from flash
Delete files to free storage space.
5. Restore to factory default
configuration
Delete the current next-
startup configuration files and restore the
factory-default configuration.
This option is available only if password recovery capability is disabled.
6. Enter BootRom upgrade menu
Access the Boot ROM upgrade menu.